SnowBikeTech Unit Stem 2 – Quick-Release Handlebar System for Snowscoot

 

Want to make your Snowscoot more compact for traveling, car storage, or the off-season?

Normally, removing the handlebar means loosening four stem bolts — and then finding your preferred handlebar angle again every time you reinstall it.

The new SnowBikeTech Unit Stem 2 offers a much smarter solution.

Its unique 3-piece construction allows you to remove the handlebar assembly simply by loosening the 10mm bolt underneath the lower section of the stem.

Your handlebar angle and setup stay exactly where you left them.

Just use a ratchet, adjustable wrench, or the same 10mm wrench commonly used for Snowscoot board bushings.

Loosen one bolt, separate the unit — done.

This makes transporting and storing your Snowscoot much easier, especially for:

• Car transport
• Train and bus travel
• Backcountry trips
• Compact off-season storage

The Unit Stem 2 also uses a top-load design, giving the handlebar a little more height — a nice option for riders who prefer a higher riding position.

 

A clever and very practical design from SnowBikeTech.

We currently have a sample on display at TOOLATE SPORTS in Japan.

We’ll share more information when the Unit Stem 2 is officially available, so keep an eye on our blog and international online store.

TOOLATE SNOWSCOOT PRO SHOP
Snowscoot specialist from Japan.
Worldwide shipping available.