TORINITY GET LOW — SNOWSCOOT Bushless Mount Kit

Board-to-Frame Attachment for Snowscoot
Lower. Lighter. Sharper. Unlock your board’s natural flex.

Why riders love it

• Bushless = no rubber. Drops the center of gravity, removes bushing stretch, and saves 200g+ vs typical non-through rubber bushing sets (actual saving depends on your stock parts).

• More board flex, more feel. Without rubber damping, the board’s own flex range opens up—closer to modern ski/snowboard binding behavior.

• Predictable edging. No bushing “lean” (one side stretching/other compressing), so the board’s roll follows the chassis. Requires less body angle to set an edge.

• Backcountry-proof. Nothing to tear. Reliable when you cannot afford a failure.

• CNC accuracy. Ultralight, logo-engraved aluminum spacers with weight-relief machining; stainless hex-socket bolts won’t rust.

• Tool-free if you want. Can be hand-tightened; for a secure final fit we recommend a 27 mm spanner/adjustable wrench.

• Easy leveling. Add the urethane shims above/below the aluminum spacers to fine-tune board level or flat setup.

Video overview: (add link here)

How it works

Rubber bushings introduce height, weight, and vertical compliance. The GET LOW Bushless concept removes them, lowering the stack, eliminating elastic lag, and letting the board—not the bushing—do the flexing. The result is a glued-to-snow feel with crisp response in jumps, gaps, and deep turns.

What’s in the box (8-point kit)

• CNC aluminum GET LOW spacer-nuts × 8

• Stainless steel bolts 35 mm × 8 (hex-socket)

• Urethane base shims × 8

• Frame/Fork mounting nuts × 8

Compatibility

• Designed for TRINITY GET LOW setups; fits most snowscoot frames that use the standard bush & bolt mount pattern.

• Bolt length: 35 mm. Use included urethane shims to match deck thickness and reach your preferred board height/level.

• Not intended to be mixed with rubber bushings.

Install (quick)

1. Remove stock bushings/hardware.

2. Place urethane shim(s) → aluminum spacer → board, align.

3. Insert stainless bolts and mounting nuts.

4. Hand-tighten, then snug with a 27 mm spanner/adjustable wrench and appropriate hex key.

5. Add/remove shims to set board level/flat.

6. Re-check tightness after the first runs.

Materials & care

• Spacers: CNC-machined aluminum

• Bolts/Nuts: Stainless steel

• Rinse after salty transport, keep threads clean, check before each riding day.